Having a hot tub at home could be a lot of fun for you and your household.
Have it at the back of your mind that a dirty hot tub could pose some threats to your well-being.
Thus, knowing how to drain your hot tub before cleaning a hot tub could be a huge relief.
This guide covers the importance of how to drain your hot tub and everyday problems associated with cleaning hot tub installations.
How to drain a hot tub – Basics
Why you should drain your hot tub
Have you wondered why it is important to drain your hot tub? Find out below!
- You should drain your hot tub to help get rid of fillers that might have accumulated due to some chemicals.
- It helps keep hot tubs clean and functioning well.
- While draining your tub, you’ll be able to check if the filters are working correctly.
- If you’ve not done any repairs on your tub for long, it’s a good idea to do so.
- If the tub is empty, you won’t find it challenging to clean.
Techniques/Tips to improve How to drain a spa
How to empty a hot tub installation
You can empty your hot tub using a spigot or a submersible pump.
Draining a hot tub with the spigot
- Ensure that the circuit breaker that is supplying power is turned off.
- Locate the drainage spigot.
- There might be two spigots attached to your tub model: primary and auxiliary.
- The primary spigot should be used to drain almost all the water.
- After that, open the auxiliary spigot to drain the internal bleed lines.
- Fix a hose to the spigot carefully.
Run the other end of it to where you want it to empty into.
- Then, open the ball valve on your spigot for it to drain.
Hot tub draining with a submersible pump
- Switch off the circuit breaker before positioning the pump inside the tub
- Your hose has to be long enough to reach the drain.
- If not, connect it to your garden hose.
- Turn on the pump and allow it to drain.
- After it has finished draining, turn off the pump and detach.
Hot tub drainage common problems
Below are some of the issues faced with hot tubs, and their solutions:
Hot tub water chemistry
Tub owners are always faced with the problem of maintaining water chemistry before using a hot tub or spa pool.
When you maintain the chemical levels, you will curb problems related to the filter compartment, sump pump, and spa drain.
Always sanitize your water and also test it regularly.
Hot tub leakages
Neglecting the chemical levels in your tub can cause the silicone seals to corrode.
Replace the O-Rings and pump seals.
How to drain a hot tub – best practices
Do you get the best from your hot tub?
These few tips will help.
Hot tub draining best practices: How to get the most from your hot tub
- Always test the tub/spa water.
- Chlorine levels at 2ppm and 5ppm are toxic to the user.
- Everyone will not have the same reaction to chlorinated water.
- It’s a good idea to maintain balanced chemical levels.
- We recommend you test your tub/spa water’s pH level at least 2 – 3 times a week.
- Applying a pH balancer will help to restore the balance.
- Your hot tub’s overall chemical content and size will determine the quantity of pH balancer to use.
Tools you can use for draining a hot tub
- Garden hose
- Submersible pump
- Clean rags
- Tub/spa shell cleaner
Spa Draining – FAQs
How do you drain a hot tub with a hose?
First of all, position the end of your garden hose inside the hot tub/spa.
Allow it to reach the bottom of the tub/spa and then turn it on to the extent that you no longer see bubbles coming out from the end.
After that, turn it off before disconnecting it from the faucet and allowing it to lie low on the floor.
You can compress it if you observe that the tap is a little bit higher than the hot tub/spa.
Let the water drain on its own from it.
Check your hot tub/spa to ensure that the hose is well placed at the tub bottom as the level of water is dropping.
Place it at the bottom of the tub/spa to suck the last of the water.
Where do you drain the water from the hot tub?
You can use a garden hose and check the front panel of your hot tub to see the hose spigot.
Look for a convenient place that you can place the tube to drain into a gutter by the street.
Don’t leave it on the lawn, to avoid a flood.
How do you dispose of hot tub water?
You can use it to irrigate your garden, but test for chlorine and pH levels first to ensure they’re safe for your plants.
You can also use it to wash your car.
How to clean hot tubs
Start by draining the tub.
Mix the chemicals you want to use in a bucket or spray bottle and stir for it to distribute appropriately.
When using a bucket, pour the solution where you want to clean and allow it to rest for 15 minutes.
Use a sponge to scrub if it is severely stained.
When the body or the cover is clean, you can wipe it and refill the hot tub.
How to drain a lay-z spa?
Take the filter housing out of the spa.
Position the two stop caps over the debris screens on the pipes inside the spa.
Disengage the pump unit.
Lastly, connect the hose adapter to the lower water pipe.
It should be outside the spa, and it should be connected to the other end to a drain area.
How to drain a beachcomber hot tub?
Take out the valve’s safety cap.
Attach one end of the hose to the drain and place the other end at a lower position to the tub for a complete drain.
After that, rotate the pipe’s outer part in a counterclockwise to open for pouring to commence.
How to drain hydro-pool hot top
The first thing is to set your hot tub on standby, and after that, remove it.
The tub air controls should be shut down, apply drain prep, set the jets on, and leave the tub for at least six hours.
At the end of the six hours, turn on the standby mode.
How to drain a hot tub with a garden hose?
Attach the hose to your yard faucet.
Once there is a flow, turn the water off at the faucet and bend a curl in the hose.
Disengage the hose from the valve, still holding the kink where the water is, then un-kink the tube.
Lastly, rinse water from the hot tub.
How to empty an Intex hot tub?
Insert the cleaning nozzle to your hose.
Pull the button under your tub out and insert the nozzle.
Push the button in, and it will start draining.
How to clean a hot tub without draining it?
Reprocess your hot tub into the swimming pool, but note that you need a pool to carry this out effectively.
Reprocess the hot tub into the bathtub before filtering the water using an outer pool filter.
While filtering the spa water, use reverse osmosis so you won’t waste energy.
Finally, wash the spa by scrubbing it well with household cleaners, including the pipes before soaking the jets.
How to clean a hot tub that has been sitting?
It’s a good idea to examine the filtering systems.
Then, clear out the container.
Re-drain and refill the tub again.
Finally, extra cleaning is required.
How to drain a hot tub without a pump?
Start with positioning one end of the hose inside the hot tub and allow it to reach the bottom of the tub
After that, turn the tube off before disconnecting it from the faucet and allowing it to lie low on the floor.
Check your hot tub to ensure that the hose is well placed at the tub bottom as the level of water is dropping.
How to clean an empty hot tub?
After the tub is empty, wear gloves and mix the chemicals that you want to use, including water and bleach in a bucket.
For people that prefer a bottle sprayer instead of a pail, then use it and spray your tub with the solution.
Leave the bleach for at least fifteen minutes before scrubbing the tub using either a sponge or rag.
How long can a hot tub sit empty?
Your hot top can sit empty for at least three months, but make sure that it is well covered.
Your hot tub can sit empty all through summer and winter, but you have to take some precautions.
How to siphon water from a bathtub?
Attach one end of the hose to the faucet.
Use your hand and force water from the faucet into the hose.
After filling it with water, allow it to rest inside the tub.
The siphon effect will pull water from the tub outside.
Can I leave my hot tub empty?
Yes, you can leave your hot tub empty, but you must take certain precautions for protection.
How to decalcify a hot tub
Mix a generous amount of vinegar with distilled water and use it to spray on your hot tub shell.
If there are plenty of stains, you can prepare a paste of baking soda and apply it to the spots where the stains are.
How to drain last bit of water from the pool
You can use an electric pool pump or a garden hose to drain a pool, but it might not remove all the contents.
To drain a pool completely, use a wet vacuum to draw or siphon the still water.
Make sure that all the liquid enters the drain.
Take away the pool liner and spray it out to dispose of the remaining water.
How often to change hot tub water
Ideally, your hot tub water should be changed every three months.
If you’re using it frequently, then you should change the water from time to time.
How to use a submersible pump?
Pick an outfall area.
Look for where to drain the liquid, like a sewage system.
Fix the outlet to the pipe.
Start by pumping from the bottom section of the water-filled area.
Submerge the pump into the water.
How to drain and refill a hot tub
Position the pump inside the tub.
If you don’t have a hose long enough to reach a drain, then connect it to a garden hose.
Turn on the pump and leave the tub to drain.
To refill your hot tub, place your hose inside the container, and turn the water on.
How to drain a portable hot tub?
Turn the tub off at the circuit breaker so that the pumps will not run when there’s no water in the tub.
Look for the drainage spigot and fix the hose to it.
Finally, open the ball valve and allow the water to drain.
How to drain a Balboa hot tub?
Make sure that you turn off your Balboa hot tub circuit breaker.
If you don’t know the circuit breaker that supplies power to your hot tub, then switch off the main breaker.
Take off your drain spigot front cover before attaching the hose to the spigot.
Run the hose to where you want the water to drain.
How to drain a Nordic hot tub?
First, locate the drain of your Nordic hot tub.
Behind the control box, reach back inside, and you’ll find a clear valve tube with a gray fitting and a hose on it.
Lift the cap up and put your garden hose onto it before opening the valve to allow water flow.
When you’re done, close the lid, and set it back inside.
How to drain a hot tub for winter?
Allow the chemicals to melt away before pouring the water.
Switch off the circuit breaker before draining the tub.
Loosen the pump fittings and heater.
After removing it, clean the filter.
Blow out lines before removing the rest of the water.
Hot tub shock how long to wait
It depends on what you’re using to shock your tub.
If you’re using non-chlorine shock, then 10 minutes should be enough for it to dissolve well inside the water.
If you’re using chlorine granules, 24 hours is enough for the chlorine level to return to 5 PPM.
We hope these tips on draining a hot tub help you get the most out of yours!